APRS Track Direct

My position About ☰

reset

E22DXH Telemetry

This is the latest recevied telemetry packets stored in our database for station/object E22DXH. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	RSSI*	Voltage*
1762240788	-51 dBm	0.59 V
1762239566	-52 dBm	0.62 V
1762238344	-53 dBm	0.62 V
1762237122	-51 dBm	0.62 V
1762235900	-52 dBm	0.57 V
1762234678	-52 dBm	0.57 V
1762233456	-52 dBm	0.57 V
1762232234	-53 dBm	0.57 V
1762231012	-51 dBm	0.57 V
1762229790	-52 dBm	0.57 V
1762228568	-53 dBm	0.59 V
1762227346	-52 dBm	0.59 V
1762226124	-53 dBm	0.59 V
1762224902	-51 dBm	0.62 V
1762223680	-54 dBm	0.66 V
1762222458	-51 dBm	0.62 V
1762221236	-55 dBm	0.66 V
1762219952	-67 dBm	0.64 V
1762218730	-68 dBm	0.66 V
1762217508	-69 dBm	0.74 V
1762216286	-66 dBm	0.62 V
1762215064	-65 dBm	0.62 V
1762213842	-71 dBm	0.62 V
1762212620	-71 dBm	0.62 V
1762211398	-71 dBm	0.62 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)