APRS Track Direct

My position About ☰

reset

ZL4AA-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ZL4AA-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Batt Volts*	PV Volts*
1732292402	12.5 V	9.8 V
1732291802	12.6 V	2.7 V
1732291202	12.6 V	0.7 V
1732290602	12.6 V	0.2 V
1732290002	12.6 V	0 V
1732289402	12.6 V	0 V
1732288803	12.6 V	0 V
1732288202	12.6 V	0 V
1732287602	12.6 V	0 V
1732287002	12.6 V	0 V
1732286402	12.6 V	0 V
1732285802	12.6 V	0 V
1732285203	12.6 V	0 V
1732284602	12.6 V	0 V
1732284002	12.6 V	0 V
1732283402	12.6 V	0 V
1732282802	12.6 V	0 V
1732282202	12.6 V	0 V
1732281602	12.6 V	0 V
1732281002	12.6 V	0 V
1732280402	12.6 V	0 V
1732279802	12.6 V	0 V
1732279202	12.6 V	0 V
1732278603	12.6 V	0 V
1732278002	12.6 V	0 V

*Used Equation Coefficients:

Batt Volts: 0, 0.1, 0

Batt Amps: 0, 0.1, 0

PV Volts: 0, 0.1, 0

PV Watts: 0, 1, 0

Value5: 0, 0.1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)