APRS Track Direct

My position About ☰

reset

SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1754117220	166 Count	553 Count	151 Count
1754115419	127 Count	413 Count	117 Count
1754111818	76 Count	256 Count	69 Count
1754110017	49 Count	166 Count	45 Count
1754095618	168 Count	527 Count	154 Count
1754084813	290 Count	1024 Count	255 Count
1754075818	152 Count	581 Count	132 Count
1754072216	85 Count	388 Count	75 Count
1754070416	57 Count	308 Count	51 Count
1754068615	31 Count	223 Count	26 Count
1754066814	21 Count	181 Count	18 Count
1754063213	199 Count	1024 Count	143 Count
1754061412	187 Count	923 Count	134 Count
1754059611	177 Count	886 Count	126 Count
1754057810	166 Count	848 Count	118 Count
1754056010	158 Count	815 Count	112 Count
1754054216	145 Count	769 Count	106 Count
1754052415	135 Count	674 Count	98 Count
1754050615	126 Count	639 Count	91 Count
1754047013	105 Count	515 Count	75 Count
1754045213	95 Count	477 Count	68 Count
1754043412	87 Count	438 Count	62 Count
1754041611	75 Count	386 Count	53 Count
1754039810	63 Count	326 Count	45 Count
1754038010	55 Count	260 Count	39 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)