APRS Track Direct

My position About ☰

reset

DG4CB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG4CB-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1778012466	33 Count	386 Count
1778010666	33 Count	386 Count
1778008865	33 Count	386 Count
1778007065	33 Count	386 Count
1778005264	33 Count	386 Count
1778003464	33 Count	386 Count
1778001664	33 Count	386 Count
1777999864	33 Count	386 Count
1777998063	33 Count	386 Count
1777996263	33 Count	386 Count
1777994480	33 Count	386 Count
1777992680	33 Count	384 Count
1777990879	33 Count	384 Count
1777989079	33 Count	384 Count
1777987279	33 Count	384 Count
1777985479	33 Count	384 Count
1777983678	33 Count	384 Count
1777981878	33 Count	384 Count
1777980077	33 Count	384 Count
1777978277	33 Count	384 Count
1777976477	33 Count	384 Count
1777974677	33 Count	384 Count
1777972876	33 Count	384 Count
1777971076	33 Count	384 Count
1777969275	33 Count	384 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)