APRS Track Direct

My position About ☰

reset

F6JON-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F6JON-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1778027849	438 Count	485 Count	392 Count
1778027246	429 Count	476 Count	384 Count
1778026643	420 Count	466 Count	376 Count
1778026039	410 Count	455 Count	367 Count
1778025436	401 Count	446 Count	359 Count
1778024223	382 Count	425 Count	342 Count
1778023762	376 Count	418 Count	337 Count
1778023159	370 Count	411 Count	332 Count
1778022556	359 Count	399 Count	322 Count
1778021952	349 Count	388 Count	313 Count
1778021349	341 Count	380 Count	306 Count
1778020745	333 Count	371 Count	299 Count
1778020142	324 Count	360 Count	291 Count
1778019533	316 Count	351 Count	284 Count
1778018930	306 Count	341 Count	275 Count
1778018326	297 Count	331 Count	267 Count
1778017723	290 Count	323 Count	261 Count
1778017116	280 Count	313 Count	252 Count
1778016513	269 Count	301 Count	242 Count
1778015903	261 Count	294 Count	235 Count
1778015300	252 Count	284 Count	227 Count
1778014697	243 Count	273 Count	219 Count
1778014093	237 Count	266 Count	214 Count
1778013490	229 Count	256 Count	207 Count
1778012887	218 Count	244 Count	197 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)