APRS Track Direct

My position About ☰

reset

TYLRPK Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TYLRPK. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732291120	137	29	74	41	48
1732289920	129	28	75	41	48
1732288722	126	29	77	41	48
1732287523	125	28	91	41	79
1732286325	126	26	76	41	48
1732285124	125	29	77	41	48
1732283925	126	25	77	41	48
1732282726	125	36	76	89	49
1732281526	125	27	79	41	48
1732280326	125	28	77	41	48
1732279128	126	29	76	41	48
1732277929	125	28	82	41	48
1732276731	126	28	77	41	48
1732275531	126	29	78	41	48
1732274330	126	29	78	41	48
1732273132	126	28	77	41	48
1732271932	126	29	78	41	49
1732270731	125	44	78	41	48
1732269531	126	27	77	41	48
1732268331	126	34	77	41	48
1732267132	126	25	75	41	48
1732265933	126	26	79	41	48
1732264734	126	26	77	41	48
1732263536	126	24	77	41	48
1732261138	126	26	76	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)