APRS Track Direct

My position About ☰

reset

IR1CX Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR1CX. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750191793	125	124	76	159	163
1750191193	125	124	76	159	162
1750190586	125	124	76	158	161
1750189985	125	124	76	157	160
1750189378	125	124	76	158	159
1750188778	125	124	76	159	160
1750188171	125	124	76	160	160
1750187571	125	124	76	161	160
1750186964	125	124	76	163	161
1750186363	125	124	76	166	162
1750185756	126	124	76	170	164
1750185156	126	125	76	177	165
1750184549	126	125	76	185	167
1750183949	126	126	76	196	169
1750183341	126	127	76	209	174
1750182741	127	127	76	211	177
1750182134	127	128	76	207	179
1750181534	127	128	76	208	179
1750180927	128	130	76	207	179
1750180326	128	130	76	201	176
1750179719	128	132	76	191	175
1750179119	127	130	76	187	174
1750178512	127	130	76	186	173
1750177912	128	131	76	186	173
1750177304	128	131	76	189	173

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)