APRS Track Direct

My position About ☰

reset

PY5LF-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5LF-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732473211	134	185	179	140	139
1732472907	135	190	183	141	140
1732472603	134	186	180	140	140
1732472300	134	185	179	140	139
1732471993	135	195	184	141	141
1732471690	133	182	176	139	138
1732471387	131	179	174	137	136
1732471086	135	205	197	141	141
1732470786	135	203	194	141	141
1732470485	135	196	185	141	141
1732470185	134	186	180	140	140
1732469884	135	201	190	141	141
1732469584	135	194	185	141	141
1732469280	135	200	189	141	141
1732468979	135	204	195	141	141
1732468678	135	188	182	141	140
1732468377	135	201	191	141	141
1732468077	135	202	193	141	141
1732467776	135	194	185	141	141
1732467475	132	199	191	140	139
1732467174	135	203	194	141	141
1732466874	135	204	194	141	141
1732466573	135	209	199	141	141
1732466272	132	181	174	138	136
1732465972	135	201	192	141	141

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)