APRS Track Direct

My position About ☰

reset

LW3HBV-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW3HBV-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1836274374	-17 dBm	12.24 V
1836274202	-17 dBm	12.24 V
1774463178	-2 dBm	12.26 V
1774462256	-3 dBm	12.26 V
1774461334	-3 dBm	12.26 V
1774460412	-2 dBm	12.26 V
1774459490	-1 dBm	12.26 V
1774458568	-2 dBm	12.26 V
1774457646	-2 dBm	12.26 V
1774456724	-2 dBm	12.26 V
1774455681	-3 dBm	12.26 V
1774454759	-3 dBm	12.26 V
1774453837	-1 dBm	12.26 V
1774452915	-2 dBm	12.26 V
1774451993	-2 dBm	12.26 V
1774451072	-2 dBm	12.26 V
1774450149	-2 dBm	12.26 V
1774449227	-3 dBm	12.26 V
1774448305	-2 dBm	12.3 V
1774447383	-1 dBm	12.26 V
1774446461	-3 dBm	12.26 V
1774445539	-2 dBm	12.26 V
1774444616	-3 dBm	12.26 V
1774443694	-2 dBm	12.26 V
1774442772	-3 dBm	12.26 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)