APRS Track Direct

My position About ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786752397	18 Count	699 Count
1786750594	14 Count	642 Count
1786748790	13 Count	597 Count
1786747026	12 Count	555 Count
1786745223	11 Count	491 Count
1786743420	7 Count	442 Count
1786741616	6 Count	372 Count
1786739813	5 Count	315 Count
1786738009	4 Count	222 Count
1786736206	1 Count	153 Count
1786734402	0 Count	76 Count
1786732599	18 Count	1027 Count
1786730795	17 Count	951 Count
1786728991	14 Count	871 Count
1786727188	13 Count	783 Count
1786725426	12 Count	695 Count
1786723622	11 Count	594 Count
1786721819	8 Count	515 Count
1786720015	6 Count	440 Count
1786718212	5 Count	361 Count
1786716409	4 Count	280 Count
1786714605	1 Count	197 Count
1786712802	0 Count	93 Count
1786710998	29 Count	1049 Count
1786709194	28 Count	969 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)