APRS Track Direct

My position About ☰

reset

SP5UID-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1786733911	2 Count	820 Count
1786730313	1 Count	439 Count
1786726712	0 Count	1 Count
1786723112	1 Count	644 Count
1786719510	0 Count	255 Count
1786715911	3 Count	1142 Count
1786712310	2 Count	875 Count
1786708711	1 Count	567 Count
1786705110	0 Count	274 Count
1786701517	5 Count	1260 Count
1786697915	4 Count	1000 Count
1786694310	3 Count	721 Count
1786690709	2 Count	466 Count
1786687110	1 Count	239 Count
1786683509	0 Count	0 Count
1786679910	3 Count	829 Count
1786676309	2 Count	541 Count
1786672710	1 Count	279 Count
1786669109	0 Count	0 Count
1786665509	3 Count	849 Count
1786661908	2 Count	567 Count
1786658308	1 Count	281 Count
1786654707	0 Count	0 Count
1786651108	3 Count	910 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)