APRS Track Direct

My position About ☰

reset

SP1APG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1APG-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1766178309	153 Count	21 Count	21 Count
1766176508	152 Count	21 Count	21 Count
1766174714	151 Count	21 Count	21 Count
1766172914	150 Count	21 Count	21 Count
1766171113	149 Count	21 Count	21 Count
1766169312	148 Count	21 Count	21 Count
1766167512	147 Count	21 Count	21 Count
1766165711	146 Count	21 Count	21 Count
1766163910	145 Count	21 Count	21 Count
1766162110	144 Count	21 Count	21 Count
1766160309	143 Count	21 Count	21 Count
1766158508	142 Count	21 Count	21 Count
1766156708	141 Count	21 Count	21 Count
1766154907	140 Count	21 Count	21 Count
1766153116	139 Count	21 Count	21 Count
1766151315	138 Count	21 Count	21 Count
1766149515	129 Count	13 Count	13 Count
1766147714	128 Count	13 Count	13 Count
1766145913	127 Count	13 Count	13 Count
1766144113	126 Count	13 Count	13 Count
1766131514	119 Count	13 Count	13 Count
1766129713	118 Count	13 Count	13 Count
1766127912	117 Count	13 Count	13 Count
1766126112	116 Count	13 Count	13 Count
1766124311	115 Count	13 Count	13 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)