APRS Track Direct

My position About ☰

reset

KQ6DI-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KQ6DI-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1745069399	365	650	607	583	460
1745068498	365	652	610	583	462
1745067599	370	654	611	582	463
1745066699	365	655	613	579	464
1745065799	365	658	615	578	465
1745064898	370	661	618	575	467
1745063998	376	663	620	572	467
1745063099	376	666	623	571	469
1745062199	376	668	625	566	469
1745061298	370	671	628	567	472
1745060398	381	673	630	567	474
1745059499	381	676	633	565	476
1745058599	381	677	635	563	476
1745057698	386	681	637	557	476
1745056799	386	684	641	554	478
1745055899	386	686	643	554	480
1745054998	386	690	647	552	482
1745054097	386	694	651	550	485
1745053199	397	696	654	546	486
1745052299	392	699	658	543	488
1745051399	397	702	661	540	489
1745050497	392	706	663	536	490
1745049599	397	709	668	535	493
1745048699	397	712	669	531	493
1745047799	397	715	673	530	496

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)