APRS Track Direct

My position About ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1836274370	672 Count	0 Count
1836274227	673 Count	0 Count
1762253585	872 Count	587 Count
1762252979	871 Count	587 Count
1762252373	870 Count	586 Count
1762251767	869 Count	585 Count
1762251161	868 Count	585 Count
1762250555	867 Count	584 Count
1762249948	866 Count	583 Count
1762249342	865 Count	583 Count
1762248736	864 Count	582 Count
1762248130	863 Count	581 Count
1762247524	862 Count	581 Count
1762246917	861 Count	580 Count
1762246311	860 Count	580 Count
1762245705	859 Count	580 Count
1762245098	858 Count	577 Count
1762244492	857 Count	575 Count
1762243886	856 Count	575 Count
1762243279	855 Count	574 Count
1762242673	854 Count	573 Count
1762242067	853 Count	573 Count
1762241461	852 Count	572 Count
1762240855	851 Count	571 Count
1762240249	850 Count	571 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)