APRS Track Direct

My position About ☰

reset

VK3RPG-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK3RPG-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732290934	72	137	33	66	37
1732289132	72	137	19	66	7
1732287332	72	137	26	65	37
1732285533	73	137	20	65	7
1732283732	73	137	23	64	37
1732281932	73	137	18	64	7
1732280133	74	137	25	63	37
1732278332	74	137	20	63	7
1732276533	75	137	31	62	37
1732274732	75	137	25	62	7
1732272933	76	137	29	61	37
1732271133	76	137	26	61	7
1732269333	77	137	32	72	37
1732267533	77	137	28	72	7
1732265732	78	137	23	51	37
1732263933	78	137	20	51	7
1732262133	79	137	26	50	37
1732260332	79	137	21	50	7
1732258532	79	137	23	49	37
1732256732	79	137	19	49	7
1732254931	79	138	28	48	37
1732253132	78	138	27	48	7
1732251331	78	138	40	47	37
1732249531	77	138	40	47	7
1732247731	77	137	40	46	37

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)