APRS Track Direct

My position About ☰

reset

KC9YTT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC9YTT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1732308772	255	61	41	42	41
1732307571	255	62	41	42	42
1732305169	255	62	41	42	43
1732300351	255	62	41	42	42
1732296689	255	62	42	42	43
1732291880	255	62	41	42	41
1732289438	255	62	41	42	42
1732288072	255	61	40	41	41
1732286786	255	62	41	42	43
1732284282	255	61	40	41	41
1732282985	255	61	41	42	42
1732279275	255	61	41	41	41
1732278074	255	62	41	42	41
1732276844	255	61	40	41	40
1732275145	255	61	41	41	42
1732273944	255	61	40	41	41
1732272742	255	61	41	42	40
1732271541	255	61	41	42	42
1732270340	255	61	41	41	41
1732269139	255	61	40	41	41
1732267937	255	61	41	42	42
1732266730	255	61	40	41	41
1732263088	255	62	41	42	42
1732261887	255	62	41	42	43
1732260685	255	62	41	42	43

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)