APRS Track Direct

My position About ☰

reset

YB1BBW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YB1BBW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1751233219	-73 dBm	0.06 V
1751232296	-74 dBm	0.02 V
1751231373	-72 dBm	0 V
1751230450	-73 dBm	0.04 V
1751229528	-73 dBm	0.02 V
1751228605	-74 dBm	0.06 V
1751227682	-72 dBm	0.02 V
1751226759	-73 dBm	0.04 V
1751225837	-73 dBm	0.02 V
1751224914	-73 dBm	0.04 V
1751223991	-73 dBm	0.02 V
1751223069	-72 dBm	0.04 V
1751222146	-73 dBm	0.02 V
1751221224	-72 dBm	0.02 V
1751220301	-74 dBm	0.06 V
1751219378	-73 dBm	0.02 V
1751218456	-72 dBm	0.04 V
1751217533	-73 dBm	0.02 V
1751216610	-72 dBm	0.04 V
1751215688	-73 dBm	0.06 V
1751214765	-72 dBm	0.06 V
1751213842	-73 dBm	0.04 V
1751212919	-73 dBm	0.02 V
1751211996	-72 dBm	0.04 V
1751211073	-72 dBm	0.02 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)