APRS Track Direct

My position About ☰

reset

SQ4HSE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4HSE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1836274809	94 Count	53 Count	39 Count
1762288892	68 Count	195 Count	49 Count
1762285290	65 Count	190 Count	47 Count
1762281694	58 Count	176 Count	41 Count
1762278089	55 Count	130 Count	39 Count
1762274488	49 Count	87 Count	34 Count
1762270957	46 Count	82 Count	32 Count
1762267357	43 Count	77 Count	30 Count
1762263756	40 Count	72 Count	28 Count
1762260154	37 Count	68 Count	26 Count
1762256554	34 Count	59 Count	24 Count
1762252953	30 Count	54 Count	21 Count
1762249352	27 Count	49 Count	19 Count
1762245751	23 Count	44 Count	16 Count
1762242151	20 Count	39 Count	14 Count
1762238549	17 Count	34 Count	12 Count
1762234948	14 Count	25 Count	10 Count
1762231346	11 Count	20 Count	8 Count
1762227745	8 Count	15 Count	6 Count
1762224145	5 Count	10 Count	4 Count
1762220543	2 Count	5 Count	2 Count
1762216942	826 Count	1007 Count	643 Count
1762213341	823 Count	998 Count	641 Count
1762209740	820 Count	993 Count	639 Count
1762206138	817 Count	988 Count	637 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)