APRS Track Direct

My position About ☰

reset

N4SFL-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N4SFL-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	DigiRpt*	Temp*
1762299456	451 Pkts	71 Pkts	36 C
1762295855	488 Pkts	83 Pkts	36 C
1762292259	476 Pkts	90 Pkts	37 C
1762288654	484 Pkts	89 Pkts	39 C
1762285054	394 Pkts	71 Pkts	39 C
1762281454	422 Pkts	68 Pkts	39 C
1762277854	430 Pkts	73 Pkts	39 C
1762274255	456 Pkts	76 Pkts	39 C
1762267457	403 Pkts	84 Pkts	37 C
1762263857	488 Pkts	106 Pkts	37 C
1762260257	433 Pkts	98 Pkts	35 C
1762256661	462 Pkts	112 Pkts	35 C
1762249458	520 Pkts	163 Pkts	35 C
1762245857	465 Pkts	139 Pkts	34 C
1762242257	467 Pkts	135 Pkts	34 C
1762238657	450 Pkts	139 Pkts	34 C
1762235057	502 Pkts	179 Pkts	35 C
1762227860	437 Pkts	136 Pkts	35 C
1762224257	421 Pkts	119 Pkts	34 C
1762220661	442 Pkts	107 Pkts	35 C
1762217057	415 Pkts	100 Pkts	35 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)