APRS Track Direct

My position About ☰

reset

KC2SYF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC2SYF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	RFiGate*	DigiRpt*	Temp*
1749314240	162 Pkts	152 Pkts	45 Pkts	26 C
1749310640	198 Pkts	190 Pkts	49 Pkts	26 C
1749307040	159 Pkts	150 Pkts	38 Pkts	26 C
1749303440	177 Pkts	170 Pkts	41 Pkts	26 C
1749299841	121 Pkts	113 Pkts	29 Pkts	26 C
1749296241	104 Pkts	100 Pkts	34 Pkts	26 C
1749292641	146 Pkts	139 Pkts	43 Pkts	26 C
1749289039	82 Pkts	78 Pkts	30 Pkts	26 C
1749285439	40 Pkts	35 Pkts	13 Pkts	26 C
1749281842	97 Pkts	92 Pkts	31 Pkts	26 C
1749278240	166 Pkts	158 Pkts	45 Pkts	26 C
1749274640	139 Pkts	131 Pkts	35 Pkts	26 C
1749271042	77 Pkts	71 Pkts	30 Pkts	26 C
1749267441	117 Pkts	111 Pkts	41 Pkts	26 C
1749263841	96 Pkts	88 Pkts	32 Pkts	26 C
1749260239	76 Pkts	69 Pkts	30 Pkts	26 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)