APRS Track Direct

My position About ☰

reset

ND7L-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ND7L-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	RFiGate*	DigiRpt*	Temp*
1758186134	139 Pkts	134 Pkts	53 Pkts	24 C
1758178933	122 Pkts	120 Pkts	35 Pkts	24 C
1758175333	113 Pkts	110 Pkts	26 Pkts	24 C
1758171733	91 Pkts	88 Pkts	19 Pkts	25 C
1758168133	76 Pkts	76 Pkts	31 Pkts	26 C
1758164533	46 Pkts	46 Pkts	10 Pkts	26 C
1758160933	78 Pkts	77 Pkts	41 Pkts	25 C
1758157333	64 Pkts	64 Pkts	23 Pkts	26 C
1758153734	139 Pkts	138 Pkts	85 Pkts	26 C
1758150133	129 Pkts	125 Pkts	49 Pkts	26 C
1758146533	207 Pkts	201 Pkts	58 Pkts	25 C
1758142933	225 Pkts	220 Pkts	55 Pkts	26 C
1758139333	267 Pkts	260 Pkts	73 Pkts	25 C
1758135733	248 Pkts	244 Pkts	54 Pkts	25 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)