APRS Track Direct

My position About ☰

reset

EA4ATS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786732023	15 Count	762 Count
1786730219	14 Count	671 Count
1786728415	13 Count	618 Count
1786726612	12 Count	566 Count
1786724809	11 Count	522 Count
1786723005	10 Count	478 Count
1786721234	9 Count	435 Count
1786719431	8 Count	397 Count
1786717628	7 Count	352 Count
1786715824	6 Count	303 Count
1786714021	5 Count	263 Count
1786712218	4 Count	220 Count
1786710414	3 Count	175 Count
1786708611	2 Count	133 Count
1786706808	1 Count	44 Count
1786705004	0 Count	0 Count
1786703237	17 Count	959 Count
1786701433	16 Count	871 Count
1786699630	15 Count	829 Count
1786697826	14 Count	774 Count
1786696022	13 Count	728 Count
1786694218	12 Count	685 Count
1786692415	11 Count	633 Count
1786690611	10 Count	577 Count
1786688809	9 Count	522 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)