APRS Track Direct

My position About ☰

reset

F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1782502256	395 Count	808 Count	262 Count
1782501352	393 Count	805 Count	261 Count
1782500448	391 Count	802 Count	260 Count
1782499544	390 Count	797 Count	260 Count
1782498639	387 Count	791 Count	258 Count
1782497735	384 Count	786 Count	256 Count
1782496831	381 Count	780 Count	254 Count
1782495927	378 Count	775 Count	252 Count
1782495023	375 Count	769 Count	250 Count
1782494118	372 Count	763 Count	248 Count
1782493214	369 Count	759 Count	246 Count
1782492310	366 Count	755 Count	244 Count
1782491406	363 Count	750 Count	242 Count
1782490501	360 Count	745 Count	240 Count
1782489597	355 Count	739 Count	236 Count
1782488693	353 Count	733 Count	235 Count
1782487789	351 Count	730 Count	234 Count
1782486884	349 Count	727 Count	233 Count
1782485980	347 Count	724 Count	232 Count
1782485076	345 Count	718 Count	231 Count
1782484172	344 Count	716 Count	231 Count
1782483267	342 Count	713 Count	230 Count
1782482363	339 Count	709 Count	228 Count
1782481459	336 Count	703 Count	226 Count
1782480647	334 Count	700 Count	225 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)