APRS Track Direct

My position About ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1836273951	275 Count	793 Count	136 Count
1778031664	104 Count	785 Count	54 Count
1778029863	102 Count	779 Count	53 Count
1778028063	99 Count	769 Count	51 Count
1778026262	96 Count	761 Count	49 Count
1778024461	93 Count	752 Count	47 Count
1778022660	91 Count	746 Count	46 Count
1778020860	88 Count	739 Count	44 Count
1778019059	85 Count	732 Count	42 Count
1778017258	83 Count	725 Count	41 Count
1778015458	82 Count	718 Count	41 Count
1778013657	79 Count	702 Count	39 Count
1778011864	78 Count	689 Count	39 Count
1778010064	77 Count	682 Count	39 Count
1778008263	74 Count	629 Count	37 Count
1778006462	71 Count	590 Count	35 Count
1778004662	69 Count	554 Count	34 Count
1778002861	66 Count	534 Count	32 Count
1778001060	63 Count	516 Count	30 Count
1777999259	62 Count	483 Count	30 Count
1777997459	61 Count	434 Count	30 Count
1777995658	60 Count	419 Count	30 Count
1777993857	59 Count	394 Count	30 Count
1777992056	58 Count	371 Count	30 Count
1777990264	56 Count	362 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)