APRS Track Direct

My position About ☰

reset

EB2BRA-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB2BRA-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790657199	7 Count	163 Count
1790655396	6 Count	142 Count
1790653592	5 Count	126 Count
1790651789	4 Count	105 Count
1790649985	3 Count	85 Count
1790648181	2 Count	59 Count
1790646378	1 Count	37 Count
1790644575	0 Count	18 Count
1790642771	54 Count	1007 Count
1790640968	53 Count	987 Count
1790639205	52 Count	974 Count
1790637402	51 Count	961 Count
1790635598	50 Count	950 Count
1790633795	49 Count	940 Count
1790631991	48 Count	928 Count
1790630188	47 Count	920 Count
1790628385	46 Count	908 Count
1790626581	45 Count	893 Count
1790624777	44 Count	874 Count
1790622974	43 Count	857 Count
1790621171	42 Count	831 Count
1790619367	41 Count	801 Count
1790617604	40 Count	781 Count
1790615800	39 Count	758 Count
1790613997	38 Count	745 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)