APRS Track Direct

My position About ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1778041616	149 Count	901 Count	106 Count
1778039816	146 Count	885 Count	104 Count
1778038015	139 Count	859 Count	98 Count
1778036214	135 Count	842 Count	95 Count
1778034414	132 Count	825 Count	93 Count
1778032613	129 Count	811 Count	91 Count
1778030813	125 Count	791 Count	88 Count
1778029012	122 Count	771 Count	86 Count
1778027211	119 Count	757 Count	84 Count
1778025411	116 Count	736 Count	82 Count
1778023610	112 Count	714 Count	79 Count
1778021816	109 Count	692 Count	77 Count
1778020016	107 Count	669 Count	76 Count
1778018215	104 Count	641 Count	74 Count
1778016414	102 Count	620 Count	73 Count
1778014614	97 Count	598 Count	69 Count
1778012813	94 Count	581 Count	67 Count
1778011013	91 Count	558 Count	65 Count
1778009212	88 Count	533 Count	63 Count
1778007411	84 Count	517 Count	60 Count
1778005611	81 Count	509 Count	58 Count
1778003810	78 Count	495 Count	56 Count
1778002010	75 Count	483 Count	54 Count
1778000227	72 Count	471 Count	52 Count
1777998415	70 Count	455 Count	51 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)