APRS Track Direct

My position About ☰

reset

EA4GMY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4GMY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1779767962	950 Count	280 Count	194 Count
1779767059	942 Count	270 Count	187 Count
1779766156	941 Count	267 Count	187 Count
1779765253	940 Count	264 Count	187 Count
1779762543	915 Count	233 Count	165 Count
1779761641	906 Count	223 Count	157 Count
1779760738	895 Count	210 Count	147 Count
1779759835	889 Count	202 Count	142 Count
1779758931	888 Count	199 Count	142 Count
1779758028	886 Count	195 Count	141 Count
1779757125	878 Count	185 Count	134 Count
1779756222	873 Count	178 Count	130 Count
1779755319	850 Count	153 Count	108 Count
1779753512	828 Count	127 Count	88 Count
1779752609	818 Count	115 Count	79 Count
1779751212	808 Count	108 Count	75 Count
1779742251	737 Count	21 Count	18 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)