APRS Track Direct

My position About ☰

reset

NICOLI Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NICOLI. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1770163533	170	81	14	60	143
1770159933	172	70	14	63	143
1770156333	173	71	12	60	143
1770152733	178	82	14	58	143
1770149133	187	82	14	61	143
1770145541	180	71	14	58	142
1770141933	173	83	17	64	142
1770138334	168	65	10	59	142
1770134733	166	58	10	59	142
1770131133	166	61	11	57	142
1770127534	167	55	10	62	142
1770123934	167	55	9	62	143
1770120334	167	57	9	62	143
1770116734	168	57	9	66	144
1770113135	168	58	8	67	145
1770109534	168	81	8	73	145
1770105934	169	71	9	65	146
1770102334	169	57	8	58	147
1770098734	170	67	7	65	149
1770095135	170	85	15	68	153
1770091535	172	55	10	58	165
1770087935	192	70	10	58	187
1770084338	165	86	12	62	139
1770080735	165	104	19	71	139

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)