APRS Track Direct

My position About ☰

reset

N0ZO Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N0ZO. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1762335145	134	92	255	74	72
1762332141	134	92	255	74	72
1762320130	134	95	255	72	69
1762312625	134	97	255	70	67
1762305117	134	100	255	69	66
1762302114	134	99	255	69	66
1762300613	134	98	255	70	67
1762299112	134	97	255	71	68
1762293106	134	96	255	71	69
1762291604	134	96	255	72	69
1762290104	134	95	255	72	70
1762288602	134	94	255	73	70
1762287101	134	93	255	73	71
1762285600	134	93	255	74	72
1762284098	134	92	255	74	72
1762273588	134	87	255	77	76
1762272087	134	87	255	78	77
1762270586	134	86	255	78	77
1762269085	134	86	255	78	77
1762267582	134	86	255	78	77
1762258574	134	86	255	78	77
1762255572	134	86	255	78	77
1762251068	134	87	255	77	76
1762249567	134	88	255	77	76

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)