APRS Track Direct

My position About ☰

reset

HB9TJR-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object HB9TJR-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274617	160	4	147	73	124
1836274602	160	4	147	73	124
1770135339	161	3	35	73	49
1770135324	161	2	35	72	50
1770134380	161	3	35	71	49
1770134364	161	3	35	72	50
1770133419	161	3	35	73	49
1770133404	161	3	35	73	49
1770132459	161	3	35	72	50
1770132444	161	2	35	71	49
1770131499	162	82	35	72	49
1770131484	162	83	35	71	49
1770130539	163	146	35	72	50
1770129579	163	168	35	72	50
1770129564	163	168	35	71	50
1770128640	163	201	35	71	49
1770128619	163	199	35	72	49
1770128604	163	201	35	71	49
1770127659	162	197	35	72	49
1770127644	165	197	35	71	49
1770126699	162	237	35	72	49
1770125726	162	262	35	73	50
1770124779	156	40	35	71	49
1770124764	158	40	35	73	49
1770123819	158	51	35	71	49

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)