APRS Track Direct

My position About ☰

reset

EA4ATS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ATS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1836274555	10 Count	406 Count
1766206332	10 Count	591 Count
1766204529	9 Count	541 Count
1766202726	8 Count	490 Count
1766200922	7 Count	438 Count
1766199157	6 Count	374 Count
1766197354	5 Count	311 Count
1766195550	4 Count	267 Count
1766193747	3 Count	224 Count
1766191944	2 Count	173 Count
1766190141	1 Count	122 Count
1766188338	0 Count	46 Count
1766186536	19 Count	1035 Count
1766184731	18 Count	980 Count
1766182928	17 Count	938 Count
1766181125	16 Count	886 Count
1766179322	15 Count	835 Count
1766177559	14 Count	783 Count
1766175756	13 Count	734 Count
1766173952	12 Count	694 Count
1766172149	11 Count	648 Count
1766170346	10 Count	610 Count
1766168543	9 Count	564 Count
1766166740	8 Count	526 Count
1766164936	7 Count	469 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)