APRS Track Direct

My position About ☰

reset

KK4ZDZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KK4ZDZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RFIn*	RFiGate*	DigiRpt*	Temp*
1744042258	196 Pkts	190 Pkts	72 Pkts	53 C
1744038658	174 Pkts	169 Pkts	66 Pkts	52 C
1744035058	225 Pkts	222 Pkts	77 Pkts	52 C
1744031458	223 Pkts	217 Pkts	94 Pkts	52 C
1744027858	107 Pkts	103 Pkts	48 Pkts	52 C
1744024258	74 Pkts	72 Pkts	39 Pkts	52 C
1744020658	133 Pkts	130 Pkts	74 Pkts	52 C
1744017058	120 Pkts	117 Pkts	59 Pkts	52 C
1744013458	126 Pkts	124 Pkts	58 Pkts	52 C
1744009858	133 Pkts	130 Pkts	73 Pkts	52 C
1744006258	144 Pkts	140 Pkts	80 Pkts	52 C
1744002658	121 Pkts	115 Pkts	70 Pkts	52 C
1743999058	61 Pkts	57 Pkts	26 Pkts	52 C
1743995459	19 Pkts	13 Pkts	4 Pkts	52 C
1743991858	44 Pkts	38 Pkts	24 Pkts	52 C

*Used Equation Coefficients:

RFIn: 0, 1, 0

RFiGate: 0, 1, 0

DigiRpt: 0, 1, 0

Temp: 0, 1, 0

InetiGate: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)