APRS Track Direct

My position About ☰

reset

KC4UG-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KC4UG-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274726	255	176	136	100	60
1836274064	255	177	136	100	61
1774145232	255	177	136	100	59
1774144571	255	177	135	100	59
1774143247	255	177	136	101	60
1774141924	255	177	136	101	59
1774126705	255	177	137	101	59
1774117442	255	177	137	102	60
1774116780	255	177	138	102	60
1774114795	255	181	139	103	61
1774111487	255	178	138	103	61
1774109502	255	178	138	103	61
1774107517	255	178	138	102	60
1774104870	255	178	138	102	58
1774103547	255	177	136	101	62
1774100237	255	177	137	102	60
1774099577	255	178	138	103	61
1774098915	255	178	138	102	60
1774096931	255	177	137	102	62
1774096268	255	177	138	102	61
1774095606	255	177	138	102	60
1774094945	255	178	138	102	60
1774092959	255	177	138	102	59
1774090976	255	177	138	102	57
1774090313	255	177	137	102	59

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)