APRS Track Direct

My position About ☰

reset

KF5BCX-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF5BCX-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790661636	128	78	255	88	71
1790657956	130	83	255	94	80
1790654346	130	85	255	93	79
1790652544	130	86	255	92	78
1790650740	130	87	255	92	77
1790648938	130	87	255	92	77
1790647056	131	89	255	91	76
1790645253	131	90	255	90	74
1790643450	131	91	255	89	73
1790641648	131	91	255	89	73
1790639846	131	96	255	86	69
1790607262	155	103	255	82	67
1790601777	141	89	255	91	76
1790599970	137	82	255	95	81
1790598168	131	77	255	97	86
1790596364	121	74	255	99	90
1790594558	124	75	255	99	88
1790592749	128	75	255	98	87
1790589139	127	74	255	92	74
1790589058	128	76	255	98	85
1790583647	129	77	255	97	84
1790581845	128	78	255	97	86

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)