APRS Track Direct

My position About ☰

reset

SNOW Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SNOW. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786726099	143	42	30	23	123
1786723549	143	41	30	23	123
1786720999	143	41	30	23	123
1786718449	136	42	30	23	123
1786715899	129	42	30	23	123
1786713349	128	41	30	23	123
1786710799	128	42	30	23	123
1786708249	128	42	30	23	123
1786705700	129	42	30	23	123
1786703149	129	42	30	23	123
1786700599	129	42	30	23	123
1786698049	129	41	30	23	123
1786695500	129	41	30	23	123
1786692949	129	42	30	23	123
1786690398	129	42	30	23	123
1786687849	129	41	30	23	123
1786685298	130	41	30	23	123
1786682748	130	41	30	23	123
1786680199	130	41	30	23	123
1786677648	132	41	30	23	123
1786675098	137	41	30	23	123
1786672549	137	41	30	23	123
1786669998	137	41	30	23	123
1786667448	137	41	30	23	123
1786664898	137	41	30	23	123

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)