APRS Track Direct

My position About ☰

reset

VK7MBD-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK7MBD-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274459	140	9	255	86	68
1770423257	144	14	255	81	60
1770422355	146	14	255	81	61
1770421453	144	14	255	82	61
1770420551	135	13	255	82	61
1770419647	137	13	255	82	61
1770418745	145	13	255	82	62
1770417844	137	13	255	82	62
1770416942	136	12	255	83	62
1770416041	135	12	255	83	62
1770415139	134	12	255	83	63
1770414238	134	12	255	83	63
1770413336	132	11	255	84	63
1770412434	133	11	255	84	64
1770411533	132	11	255	84	64
1770410631	128	10	255	85	65
1770409730	125	10	255	85	65
1770408827	124	10	255	85	66
1770407926	124	10	255	86	66
1770407024	123	10	255	86	66
1770406123	124	9	255	87	67
1770405221	121	4	255	71	46
1770404494	124	10	255	86	66
1770403592	124	10	255	86	66
1770402691	124	10	255	86	66

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)