APRS Track Direct

My position About ☰

reset

IW9GTR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1836274184	209 Count	595 Count	140 Count
1762309480	962 Count	914 Count	580 Count
1762308271	957 Count	908 Count	577 Count
1762307063	953 Count	904 Count	575 Count
1762305854	944 Count	895 Count	568 Count
1762304645	938 Count	890 Count	564 Count
1762303436	934 Count	887 Count	562 Count
1762302389	929 Count	883 Count	559 Count
1762301180	922 Count	878 Count	554 Count
1762299972	918 Count	876 Count	552 Count
1762298763	914 Count	874 Count	550 Count
1762297554	908 Count	869 Count	546 Count
1762296345	904 Count	865 Count	544 Count
1762295136	898 Count	859 Count	540 Count
1762293928	891 Count	852 Count	535 Count
1762292719	887 Count	848 Count	533 Count
1762291510	882 Count	843 Count	530 Count
1762290300	875 Count	836 Count	525 Count
1762289090	871 Count	831 Count	523 Count
1762287881	865 Count	825 Count	519 Count
1762286672	859 Count	819 Count	515 Count
1762285462	855 Count	815 Count	513 Count
1762284253	847 Count	807 Count	507 Count
1762283045	841 Count	801 Count	503 Count
1762281836	837 Count	797 Count	501 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)