APRS Track Direct

My position About ☰

reset

SV9KIR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV9KIR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762334241	604 Count	800 Count
1762332438	603 Count	800 Count
1762330635	602 Count	800 Count
1762328832	601 Count	800 Count
1762327029	600 Count	800 Count
1762325225	599 Count	800 Count
1762323422	598 Count	800 Count
1762321619	597 Count	800 Count
1762319816	596 Count	794 Count
1762318013	595 Count	792 Count
1762316210	594 Count	791 Count
1762314443	593 Count	789 Count
1762312640	592 Count	787 Count
1762310837	591 Count	783 Count
1762309034	590 Count	780 Count
1762307231	589 Count	778 Count
1762305428	588 Count	776 Count
1762303625	587 Count	774 Count
1762301822	586 Count	772 Count
1762300019	585 Count	770 Count
1762298216	584 Count	768 Count
1762296413	583 Count	766 Count
1762294610	582 Count	764 Count
1762292842	581 Count	762 Count
1762291039	580 Count	760 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)