APRS Track Direct

My position About ☰

reset

QUAIL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object QUAIL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1790629706	135	28	74	41	48
1790629092	133	0	58	89	48
1790628469	139	25	72	41	48
1790627853	133	29	71	76	48
1790627234	133	26	73	41	78
1790626617	131	73	71	73	48
1790625993	133	27	74	41	48
1790625376	132	26	74	41	48
1790624761	130	29	73	41	48
1790624142	136	26	72	41	48
1790623525	139	50	70	41	48
1790622908	143	29	71	41	48
1790622289	144	72	70	41	48
1790621671	137	0	57	41	48
1790621049	132	37	72	41	48
1790620429	130	28	76	41	48
1790619805	131	29	104	41	48
1790619183	129	64	74	41	48
1790618567	127	34	67	41	48
1790617949	126	28	73	41	48
1790617334	122	0	47	42	48
1790616710	124	3	61	40	47
1790616087	125	28	75	41	48
1790615465	125	25	73	41	48
1790614849	124	33	74	41	48

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)