APRS Track Direct

My position About ☰

reset

OK4RS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1790648631	974 Count	88 Count	78 Count
1790646828	973 Count	88 Count	78 Count
1790645025	972 Count	88 Count	78 Count
1790643291	971 Count	88 Count	78 Count
1790641488	970 Count	88 Count	78 Count
1790639685	969 Count	88 Count	78 Count
1790637881	968 Count	88 Count	78 Count
1790636078	967 Count	88 Count	78 Count
1790632472	965 Count	88 Count	78 Count
1790630669	964 Count	88 Count	78 Count
1790628866	963 Count	88 Count	78 Count
1790627063	962 Count	88 Count	78 Count
1790625260	961 Count	88 Count	78 Count
1790623456	960 Count	88 Count	78 Count
1790621660	959 Count	88 Count	78 Count
1790619856	958 Count	88 Count	78 Count
1790618053	957 Count	88 Count	78 Count
1790616250	956 Count	88 Count	78 Count
1790614447	955 Count	88 Count	78 Count
1790612646	954 Count	88 Count	78 Count
1790610840	951 Count	86 Count	76 Count
1790609037	950 Count	86 Count	76 Count
1790607234	949 Count	86 Count	76 Count
1790605441	948 Count	86 Count	76 Count
1790603628	944 Count	83 Count	73 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)