APRS Track Direct

My position About ☰

reset

ALMOSA Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ALMOSA. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1750192999	177	138	71	41	127
1750189399	175	139	72	41	127
1750187599	174	138	71	41	127
1750185799	182	137	71	41	127
1750183999	170	136	70	40	127
1750182199	177	135	70	40	126
1750180400	144	140	72	41	127
1750178599	170	135	70	40	126
1750176800	141	137	71	41	127
1750175000	140	135	70	40	127
1750173200	137	134	69	40	127
1750171400	133	131	68	39	126
1750169600	133	130	67	39	126
1750167800	127	125	66	38	126
1750162400	123	123	64	38	126
1750160600	123	123	64	38	126
1750158800	4	123	64	38	126
1750157000	4	123	64	37	124
1750155200	4	123	64	38	124
1750153400	4	123	64	38	124
1750151600	3	123	65	38	124
1750149800	4	123	65	38	124
1750146200	124	124	65	38	126
1750144400	124	124	65	38	126
1750142600	125	124	65	38	126

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)