APRS Track Direct

My position About ☰

reset

PY5CTV-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PY5CTV-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1786740878	124	9	9	127	127
1786740278	124	24	28	127	127
1786739671	124	41	45	127	127
1786739071	124	78	72	128	128
1786738469	125	100	89	128	128
1786737848	123	110	95	127	127
1786737788	120	130	106	124	124
1786737748	124	140	116	127	127
1786737418	125	165	137	128	128
1786737093	125	165	137	128	128
1786736789	126	169	147	129	129
1786736481	123	159	125	127	127
1786736065	125	166	140	129	129
1786735742	127	168	145	130	130
1786735440	127	169	145	130	130
1786735139	126	169	148	130	130
1786734839	127	169	149	130	130
1786734539	127	169	146	130	130
1786734238	127	168	145	130	130
1786733937	127	170	150	130	130
1786733636	128	170	150	131	131
1786733335	129	173	158	132	132
1786733032	129	173	156	132	132
1786732731	130	177	164	133	133
1786732428	131	177	165	134	133

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)