APRS Track Direct

My position About ☰

reset

AF5LI-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object AF5LI-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1758151143	3322	471	18	600	1271
1758151023	3228	1130	17	600	1266
1758150904	2856	638	15	613	1268
1758150784	3086	1112	26	619	1269
1758150664	3749	485	27	639	1262
1758150544	3731	586	20	664	1254
1758150424	3218	516	17	653	1262
1758150304	3548	629	19	672	1262
1758150215	3684	626	16	692	1259
1758150184	2767	1107	17	627	1261
1758150064	3495	656	32	633	1257
1758149944	3684	626	16	692	1259
1758149824	3181	702	25	682	1260
1758149723	3546	1156	24	693	1255
1758149704	4222	752	22	733	1255
1758149465	3546	1156	24	693	1255
1758149345	3253	1139	11	702	1253
1758149105	3324	770	30	720	1253
1758148985	3817	802	38	733	1254
1758148865	3147	1117	49	768	1249
1758148846	2871	746	60	776	1250
1758148682	2867	740	49	716	1251
1758148623	3645	767	21	766	1249
1758148564	2908	843	68	759	1250
1758148462	2867	740	49	716	1251

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)