APRS Track Direct

My position About ☰

reset

JA2YQQ-4 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object JA2YQQ-4. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1836274189	142	181	255	87	61
1836274045	142	181	255	87	61
1778042343	142	174	255	94	68
1778041442	142	174	255	94	68
1778040542	142	174	255	94	68
1778039641	142	173	255	94	68
1778038740	142	173	255	94	68
1778037839	142	173	255	94	68
1778036938	142	173	255	94	68
1778036037	142	173	255	94	68
1778035136	142	173	255	94	68
1778034235	142	173	255	94	68
1778033334	142	173	255	94	68
1778032433	142	173	255	94	68
1778031532	142	173	255	94	69
1778030632	142	173	255	94	69
1778029731	142	173	255	94	69
1778028830	142	172	255	94	69
1778027929	142	172	255	94	69
1778027028	142	172	255	94	69
1778026133	142	172	255	94	69
1778025226	142	172	255	94	69
1778024325	142	172	255	94	69
1778023424	142	172	255	94	69
1778022523	142	172	255	95	69

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)