APRS Track Direct

My position About ☰

reset

YD1ION-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YD1ION-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RSSI*	Voltage*
1774145119	-47 dBm	6.69 V
1774144209	-49 dBm	6.71 V
1774143299	-47 dBm	6.71 V
1774141987	-48 dBm	6.79 V
1774141077	-47 dBm	6.71 V
1774140167	-48 dBm	6.69 V
1774139257	-50 dBm	6.71 V
1774137923	-46 dBm	6.79 V
1774137013	-47 dBm	6.77 V
1774136103	-49 dBm	6.64 V
1774135193	-49 dBm	6.79 V
1774132188	-48 dBm	6.71 V
1774131278	-49 dBm	6.79 V
1774130368	-48 dBm	6.73 V
1774129458	-52 dBm	6.71 V
1774128454	-48 dBm	6.73 V
1774127544	-45 dBm	6.69 V
1774126634	-45 dBm	6.71 V
1774125724	-44 dBm	6.67 V
1774124720	-47 dBm	6.64 V
1774123810	-51 dBm	6.73 V
1774122900	-47 dBm	6.69 V
1774121990	-48 dBm	6.71 V
1774120986	-46 dBm	6.75 V
1774120076	-49 dBm	6.75 V

*Used Equation Coefficients:

RxTraffic: 0, 1, 0

TxTraffic: 0, 1, 0

RxDrop: 0, 1, 0

RSSI: 0, -1, 0

Voltage: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)