APRS Track Direct

My position About ☰

reset

IR1DD Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR1DD. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1745130986	137	178	97	112	140
1745130370	135	152	96	111	139
1745129752	135	153	97	112	139
1745129125	134	145	97	113	139
1745128516	134	143	97	113	140
1745127907	133	144	96	114	140
1745127281	132	125	96	114	141
1745126675	131	124	95	113	143
1745126047	131	124	93	111	144
1745125428	129	111	93	112	145
1745124804	131	124	92	112	146
1745124189	131	124	92	112	146
1745123560	131	124	92	109	146
1745122950	131	124	92	108	146
1745122345	130	119	92	107	146
1745121734	130	119	91	107	145
1745121124	131	119	91	105	145
1745120518	131	119	91	109	144
1745119908	130	119	92	111	144
1745119300	131	119	92	111	144
1745118691	131	119	92	113	144
1745118070	131	119	93	112	144
1745117462	130	119	93	114	144
1745116852	128	99	93	112	144
1745116230	131	119	93	112	144

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)