APRS Track Direct

My position About ☰

reset

SP9DAT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1750147377	214 Count	511 Count	162 Count
1750146477	212 Count	506 Count	161 Count
1750144675	206 Count	499 Count	157 Count
1750143774	203 Count	493 Count	155 Count
1750142873	200 Count	483 Count	153 Count
1750141972	192 Count	471 Count	146 Count
1750141071	188 Count	462 Count	143 Count
1750140170	184 Count	455 Count	140 Count
1750139269	179 Count	446 Count	136 Count
1750138368	175 Count	439 Count	133 Count
1750137468	171 Count	428 Count	130 Count
1750136567	168 Count	422 Count	128 Count
1750135666	165 Count	414 Count	126 Count
1750134765	161 Count	406 Count	123 Count
1750133864	157 Count	397 Count	120 Count
1750132963	154 Count	390 Count	118 Count
1750132062	150 Count	381 Count	115 Count
1750131161	147 Count	374 Count	113 Count
1750129359	139 Count	356 Count	107 Count
1750128460	135 Count	347 Count	104 Count
1750127558	131 Count	339 Count	101 Count
1750126657	127 Count	327 Count	98 Count
1750125756	123 Count	318 Count	95 Count
1750124855	120 Count	310 Count	93 Count
1750123954	116 Count	303 Count	90 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)