APRS Track Direct

My position About ☰

reset

F4FWW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4FWW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782522035	244 Count	88 Count	80 Count
1782520235	243 Count	88 Count	80 Count
1782518434	242 Count	88 Count	80 Count
1782516633	241 Count	88 Count	80 Count
1782514832	240 Count	88 Count	80 Count
1782513032	239 Count	88 Count	80 Count
1782511239	238 Count	88 Count	80 Count
1782509438	237 Count	88 Count	80 Count
1782507638	236 Count	88 Count	80 Count
1782505837	235 Count	88 Count	80 Count
1782504036	234 Count	88 Count	80 Count
1782502235	233 Count	88 Count	80 Count
1782500435	232 Count	88 Count	80 Count
1782498634	231 Count	88 Count	80 Count
1782496833	230 Count	88 Count	80 Count
1782495033	229 Count	88 Count	80 Count
1782493232	228 Count	88 Count	80 Count
1782491435	227 Count	88 Count	80 Count
1782489639	226 Count	88 Count	80 Count
1782487839	225 Count	88 Count	80 Count
1782486038	224 Count	88 Count	80 Count
1782484237	212 Count	77 Count	69 Count
1782482436	204 Count	70 Count	62 Count
1782480636	203 Count	70 Count	62 Count
1782478835	202 Count	70 Count	62 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)