APRS Track Direct

My position About ☰

reset

NWCSTL Telemetry

This is the latest recevied telemetry packets stored in our database for station/object NWCSTL. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Supply*	Value2*	Value3*
1836274234	13.43 V	-0.01	-0
1766272205	13.49 V	-0.01	0.01
1766270197	13.49 V	-0.01	-0
1766268189	13.49 V	-0	0
1766266176	13.49 V	-0.01	0
1766262158	13.44 V	-0	0
1766260149	13.16 V	-0.01	0
1766258139	13.15 V	-0.01	-0
1766252111	13.49 V	-0.01	0
1766250102	12.8 V	-0	-0
1766248092	13.16 V	-0.01	-0.01
1766244073	13.49 V	-0.01	0
1766240055	13.49 V	-0	0
1766236036	13.49 V	-0.01	-0
1766234028	13.49 V	-0	-0
1766232017	13.49 V	-0.01	0.01
1766227998	13.15 V	-0.01	-0
1766225990	13.15 V	-0.01	0
1766223979	13.49 V	-0.01	0
1766221969	13.49 V	-0.01	0
1766219960	13.49 V	-0.01	0
1766217951	13.49 V	-0	-0
1766215942	13.16 V	-0.01	0
1766213932	13.49 V	-0.01	0
1766209913	13.49 V	-0.01	-0

*Used Equation Coefficients:

Supply: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)