APRS Track Direct

My position About ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1786724092	4 Count	170 Count
1786722289	3 Count	125 Count
1786720486	2 Count	80 Count
1786718683	0 Count	41 Count
1786716879	19 Count	1014 Count
1786715076	17 Count	941 Count
1786713273	16 Count	868 Count
1786711470	15 Count	820 Count
1786709667	14 Count	764 Count
1786707900	13 Count	715 Count
1786706097	12 Count	665 Count
1786704294	11 Count	627 Count
1786702491	10 Count	590 Count
1786700688	9 Count	543 Count
1786698885	8 Count	486 Count
1786697082	7 Count	433 Count
1786695278	6 Count	385 Count
1786693475	4 Count	336 Count
1786691672	3 Count	262 Count
1786689869	2 Count	194 Count
1786688066	1 Count	146 Count
1786686300	0 Count	73 Count
1786684497	13 Count	1015 Count
1786682694	12 Count	946 Count
1786680891	11 Count	874 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)